I am sure this must have been done already. I have Blackface Champ clone that I am wanting to upgrade the output transformer and have found its size will not fit in the stock location and was wondering about any complications other than wire length that may occur by putting it on the far right side close to the 12AX7? I have a 10 inch speaker with an offset baffle which allows for the positioning at the specified location.
I was considering shielding and securing the wires along the chassis entering through the existing grommet and into the wiring cavity. Thanks in advance for any consideration.
I was considering shielding and securing the wires along the chassis entering through the existing grommet and into the wiring cavity. Thanks in advance for any consideration.
The complication that I could see would be having the magnetic field from the transformer injecting noise into the 12ax7 tube .
I don't know about your champ but the champ I had back in the day had the output and power transformer in the outside of the chassis , if yours are inside the chassis maybe mounting them outside would be an option ??
I don't know about your champ but the champ I had back in the day had the output and power transformer in the outside of the chassis , if yours are inside the chassis maybe mounting them outside would be an option ??
- Status
- Not open for further replies.