http://www.partsexpress.com/pe/showdetl.cfm?&DID=7&Partnumber=295-490
hello everyone! ima build a new sub, and it's going to be di-polar. i was thinking of using 2 of the above ^^. has anyone used these? if i can't get those, then i'll get the 10" version. what i'm looking for is anyone who has had experience with the 10 or 12" versions of those! thanks!!
hello everyone! ima build a new sub, and it's going to be di-polar. i was thinking of using 2 of the above ^^. has anyone used these? if i can't get those, then i'll get the 10" version. what i'm looking for is anyone who has had experience with the 10 or 12" versions of those! thanks!!
bump, and i bought the 10" version. should i run sealed or vented? oh btw, my sn is lemans23 over at caraudio.com, so i know plenty about audio, just in case u were wondering if u could get technical with me.
You said at first it might be dipolar. Here’s the best source:
www.linkwitzlab.com/models.htm and other links at the Linkwitz site
With 10 inchers you could (as in the Linkwitz Orion, two drivers a side, with EQ) make it dipolar say 50-130 Hz, with sealed boxes below.
It would be difficult to go diploe & get it right first time. Vented would be cheaper easier.
www.linkwitzlab.com/models.htm and other links at the Linkwitz site
With 10 inchers you could (as in the Linkwitz Orion, two drivers a side, with EQ) make it dipolar say 50-130 Hz, with sealed boxes below.
It would be difficult to go diploe & get it right first time. Vented would be cheaper easier.
- Status
- Not open for further replies.