Hi,
Anyone know where to find a service manual or schematic for a Sound Technology St1500a? Slim pickings on this one.
Jim
Anyone know where to find a service manual or schematic for a Sound Technology St1500a? Slim pickings on this one.
Jim
PM me. I have scans of the ST1510 manuals. I think they will help you. I need an email because they are too big for the forum. I'll upload them to KO4BB later as well, however he doesn't make things available for a while.
Hi everyone here,
thanks for the scans of the SM.
Please do you have any picture of the extender card for the output amp board?
I think it should be like pcb with the traces turning 90 degrees up and the card edge connector on the top so the original OAB will end up in vertical position sticking out of the box. But I'm not sure about this solution. Maybe someone knows better or original.
thanks for the scans of the SM.
Please do you have any picture of the extender card for the output amp board?
I think it should be like pcb with the traces turning 90 degrees up and the card edge connector on the top so the original OAB will end up in vertical position sticking out of the box. But I'm not sure about this solution. Maybe someone knows better or original.
I just found this thread and it is so coincidental as I have an ST1510A that just lost it's "Magic Smoke" last week. I see two crispy critters that look like tantalum caps on the PreAmp board and a couple of cooked resisters behind them. I have not removed the board yet looking for a SM) and with the degree of burn, I doubt I will be able to determine the specs for replacement, hence the need for schematics.
I have looked everywhere for a Service Manual for the 1510A including KO4BB and cannot find one anywhere - and then this thread popped up .
1audio and others here, do you still have that SM scan and can I possibly get a copy ?
Thanks for consideration
Richard
I have looked everywhere for a Service Manual for the 1510A including KO4BB and cannot find one anywhere - and then this thread popped up .
1audio and others here, do you still have that SM scan and can I possibly get a copy ?
Thanks for consideration
Richard
PM me with your e-mail and I'll send the file via wetransfer. The zipped file is 64 MB
I would like to but I am still relatively new to this forum and cannot start a conversation. The admin notes are to request a PM so that I can reply .. that or just post a lot but that strikes me as spam of another color ...
I seem to be stuck 🙂
I seem to be stuck 🙂
I am also open to sharing any hard to find pdf manuals that I may have - so if you are looking for anything reel-to-reel related, I might have it
Its considered bad practice to share personal e-mails on an open forum. That usually triggers a lot of spam. . .
I sent you a PM with my e-mail. Respond to my email with yours and I'll sent the zip file.
I sent you a PM with my e-mail. Respond to my email with yours and I'll sent the zip file.
