Need schematic for Dynaudio Esotar2 EX3-650

Status
Not open for further replies.
Jump to Latest
#3
#5
mbrennwa said:
Generic crossovers are just that: generic. That's why they will never give good results in a specific build/design.

Can you explain a bit more what you're trying to do? Maybe we could help a bit better if we understand your motivation / situation.
Click to expand...


At the moment I have assembled a 3-way system on the speakers Dinaudio Esotar2 650 + 430 + 110 with active crossovers Audiocontrol 4xs.There is a desire to move to a passive division. Driving crossovers need for its repetition and further improvement / modernization.
Sound in Audi Q5 - vladimir.1953@qip.ru - Photo.Qip.ru / id: vas
 
#6
TVL said:
At the moment I have assembled a 3-way system on the speakers Dinaudio Esotar2 650 + 430 + 110 with active crossovers Audiocontrol 4xs.There is a desire to move to a passive division. Driving crossovers need for its repetition and further improvement / modernization.
Sound in Audi Q5 - [email]vladimir.1953@qip.ru[/email] - Photo.Qip.ru / id: vas
Click to expand...

Ok, then you'll need to develop a suitable passive filter for your set up. I have no experience with car installations though, but I guess the same applies as for "conventional" speaker systems: you'll need measurement equipment to guide your design. You'll need to measure things like SPL vs. frequency and electrical impedance vs. frequency of each driver, and use this as a starting point to define your filters and the associated circuit(s).
 
#7
mbrennwa said:
Ok, then you'll need to develop a suitable passive filter for your set up. I have no experience with car installations though, but I guess the same applies as for "conventional" speaker systems: you'll need measurement equipment to guide your design. You'll need to measure things like SPL vs. frequency and electrical impedance vs. frequency of each driver, and use this as a starting point to define your filters and the associated circuit(s).
Click to expand...


Measuring equipment: laptop, external sound card M-Audio Solo FW with phantom power and a microphone Behringer ECM-8000 at me there. Impedance and Thiele-Small parameters in the design can be measured. Problem is that I am listening point is not on the radiation axis, and in the zone from the axis of 15-20 degrees.The photo in the album have measurements fragments.
 
Status
Not open for further replies.
Top Bottom