Hi!
First post but I might as well jump right into it…
I’m reviving an old Chevy Silverado from 2001 and I intend to replace all speakers with something better..
In short I want to use one amplifier for each speaker, also I want to place this amplifier right next to each speaker. Idk if I want to use common low level RCA-cables, toslink(probably problematic) or some digital source. I don’t want volume control, high-pass or low-pass filters on board, instead all this should be governed by a preamp of some kind.
I’m not sure what I’m looking for honestly, but I bet you guys can point me in the right direction. I’ll figure out the IP-class issues if I get that far.
Thanks in advance!
//Johan from Sweden
First post but I might as well jump right into it…
I’m reviving an old Chevy Silverado from 2001 and I intend to replace all speakers with something better..
In short I want to use one amplifier for each speaker, also I want to place this amplifier right next to each speaker. Idk if I want to use common low level RCA-cables, toslink(probably problematic) or some digital source. I don’t want volume control, high-pass or low-pass filters on board, instead all this should be governed by a preamp of some kind.
I’m not sure what I’m looking for honestly, but I bet you guys can point me in the right direction. I’ll figure out the IP-class issues if I get that far.
Thanks in advance!
//Johan from Sweden