Hello--
I purchased the following from eBay recently:
https://www.ebay.com/itm/3335579667...rentrq:d153990117f0a45ac284f243fff69ba4|iid:1
There is a 2-Pin connection for power and a 3-Pin connection for audio.
Though the connection can be made by directly soldering wires to these pins, I'd prefer not to do that, as they are very small and there's a good chance I'll melt some of the plastic. As I am prototyping the circuit before constructing the chassis, I will need to solder - desolder - solder a final time.
My struggle right now is that I have no idea how to search Mouser to find the correct parts.
I've measured the port area and pin pitch and come up with the following:
Power
Audio
To measure the pitch, I measured the distance from pin to pin.
This seems like a decent candidate but the pitch measurement is 3mm:
https://www.mouser.com/ProductDetail/Molex/43640-0200?qs=HlEFOAM0q6UFEEdO4u/anw==
Another concern is, if I were to order the Mouser part above, how do I go about attaching the wire leads? Again, would prefer to order something with leads already attached, or at least a part which would offer a solder lug.
Thank you for any assistance provided!
I purchased the following from eBay recently:
https://www.ebay.com/itm/3335579667...rentrq:d153990117f0a45ac284f243fff69ba4|iid:1
There is a 2-Pin connection for power and a 3-Pin connection for audio.
Though the connection can be made by directly soldering wires to these pins, I'd prefer not to do that, as they are very small and there's a good chance I'll melt some of the plastic. As I am prototyping the circuit before constructing the chassis, I will need to solder - desolder - solder a final time.
My struggle right now is that I have no idea how to search Mouser to find the correct parts.
I've measured the port area and pin pitch and come up with the following:
Power
- Approximately 5mm x 7mm
- Pin Pitch 2mm
Audio
- Approximately 5mm x 10mm
- Pin Pitch 2mm
To measure the pitch, I measured the distance from pin to pin.
This seems like a decent candidate but the pitch measurement is 3mm:
https://www.mouser.com/ProductDetail/Molex/43640-0200?qs=HlEFOAM0q6UFEEdO4u/anw==
Another concern is, if I were to order the Mouser part above, how do I go about attaching the wire leads? Again, would prefer to order something with leads already attached, or at least a part which would offer a solder lug.
Thank you for any assistance provided!
search for 'jst 2mm'.
You will get multiple hits on any search.
Available pre-wired.
note audio should be screened - for a short internal run you will get away with twisting.
https://thepihut.com/products/2-0mm...MI86z5lbnp9gIVKoBQBh0e4AAaEAQYBCABEgKEBPD_BwE
You will get multiple hits on any search.
Available pre-wired.
note audio should be screened - for a short internal run you will get away with twisting.
https://thepihut.com/products/2-0mm...MI86z5lbnp9gIVKoBQBh0e4AAaEAQYBCABEgKEBPD_BwE