If someone who have the VRDS10 schematic can help me.
I need to know the value and voltage of C493 on the servo board. The capacitor explosed. One page of my schematic book is missing and I don't have the value. The capacitor is located at the left of the board close to the P409 connector.
Thanks for you help.
I need to know the value and voltage of C493 on the servo board. The capacitor explosed. One page of my schematic book is missing and I don't have the value. The capacitor is located at the left of the board close to the P409 connector.
Thanks for you help.
I made a mistake and replaced it with a 10V.
Boom when I pushed the button to open the drawer...
All is fine now.
Thanks.
Boom when I pushed the button to open the drawer...
All is fine now.
Thanks.
so replaced all stock caps to better ones and caused the error?
any idea which are the critical caps to change? i do not want to splurge on caps that do nothing but opening and closing drawers or to make the display LED to look more pretty....😀
any idea which are the critical caps to change? i do not want to splurge on caps that do nothing but opening and closing drawers or to make the display LED to look more pretty....😀
Still the same story. You work on the board. The phone ring, bla bla, and you make the mistake...
I replaced all ecaps, some film and ceramic caps (around the spdif output) in the servo board. I used Rubycon ZA, Wima MKS2, Wishay MKP1637 and some NPO. Around 45 caps...
Two hours job.
My VRDS10 is eleven years old.
I replaced all ecaps, some film and ceramic caps (around the spdif output) in the servo board. I used Rubycon ZA, Wima MKS2, Wishay MKP1637 and some NPO. Around 45 caps...
Two hours job.
My VRDS10 is eleven years old.
- Status
- Not open for further replies.