No offense intended, but this is a DIY-forum so I doubt a lot of people here want to help you design a commercial product free of charge. Suggest you either do your own research or pay someone else a fair market rate to do it for you
EDIT: Oh, and if you want to put a commercial electronics product in a foam enclosure then my recommendation would probably be for the latter approach - US liability laws in this area are particularly nasty as far as I recall.
EDIT: Oh, and if you want to put a commercial electronics product in a foam enclosure then my recommendation would probably be for the latter approach - US liability laws in this area are particularly nasty as far as I recall.
Last edited:
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.