I have deiced for a 4.7uF bi-polar capacitor for the crossover by using this calculator:
2-Way Crossover Designer / Calculator
to get a -6dB/octave crossover at 5-6000Hz (I hope).
So now it's just a matter of ordering and building 🙂
2-Way Crossover Designer / Calculator
to get a -6dB/octave crossover at 5-6000Hz (I hope).
So now it's just a matter of ordering and building 🙂
Last edited:
An externally hosted image should be here but it was not working when we last tested it.
Okay, so now I have begun building, but I'm in doubt if I should connect the to speaker cabinets so they share the same volume? I read this thread, and it seems that it would be a good idea to connect them. I've tried to make the cabinets about 3.6 liters excluding the speakers volume.
Also, as you can see in the picture, I thought I would be smart and angle the speakers a little to give better stereo image, but I also read from the mentioned thread that there's a lot of science involved in overlapping radiation patterns (placement of the drivers) etc, and I'm afraid that my angular design could sound bad?
Last edited:
- Status
- Not open for further replies.