Hi, need to know correct name of these footprints....
on Easyeda there are tons and in Eagle tons*tons*tons....
In cases like this, how should I behave?
Thanks!
on Easyeda there are tons and in Eagle tons*tons*tons....
In cases like this, how should I behave?
Thanks!
No idea about EasyEDA, but I have both in Eagle. Not sure it is the standard libraries, but the relay is called "T90" and the jack is a "Neutrik NRJ6".
Only use a footprint if you are certain of the exact part number used, and that it is currently available.
Of course, in fact I often design them myself (in Altium), but you will agree with me that the relay is a bit difficult to do...😕
There will be a mechanical drawing of the relay in the data sheet, it's no harder to make than most other footprints.
Hmmm... I'm not so sure about that. The Neutrik NRJ6HH requires some non-plated holes for some support pins. It also has the threaded bushing off centre, whereas it's drawn centred in the footprint shown. It is some kind of TRS jack but I don't think it's a Neutrik NRJ6.
Tom