Hi,
Am looking to build a cable for NAIM NAP 150 that I plan to use it to drive center channel. The ones that are available are DIN to 2 RCA cables. Am thinking Mogami 2549 and Amphenol RCA but not finding the 4 pin DIN that is for NAIM. Anyone built one and where to buy. Also should I connect positives in 4pin together? The center channel is Bowers which has two binding posts so will drive 50W 2 channels to HF and LF posts. Thoughts?
Am looking to build a cable for NAIM NAP 150 that I plan to use it to drive center channel. The ones that are available are DIN to 2 RCA cables. Am thinking Mogami 2549 and Amphenol RCA but not finding the 4 pin DIN that is for NAIM. Anyone built one and where to buy. Also should I connect positives in 4pin together? The center channel is Bowers which has two binding posts so will drive 50W 2 channels to HF and LF posts. Thoughts?
Why not add two RCA's on the back or replace the 4 pin DIN with an ordinary 3 or 5 pin type. Perhaps a 7 pin DIN would fit removing the extra pins. Check the angle.
You mean change the outlets on NAP150? I prefer to keep the the socket on NAIM the same. Just want to use it to drive center channel
No. I mean the input Din on the right side.
You can maintain it and add two panel mount RCA's
Naim Nap 150X |Jack-fi
You can maintain it and add two panel mount RCA's
Naim Nap 150X |Jack-fi
Thanks but didn't see how I can add two panel mount RCA's. Sorry if I missed looking at right page on the link.