Not sure if this is the correct place to ask but I thought I'd toss my question out there and see if anyone has any ideas.
Has anyone out there ever taken apart a NAD T763 receiver?
I am wondering if there is a recommended sequence for pulling off all of the assorted bits in order to pull the main circuit board.
One of the caps has gone bad on my main board and I am confident in my abilities to replace the bad component once the circuit board is out but... not certain of the best way to get the main board out.
Any advice is appreciated.
Thanks
Has anyone out there ever taken apart a NAD T763 receiver?
I am wondering if there is a recommended sequence for pulling off all of the assorted bits in order to pull the main circuit board.
One of the caps has gone bad on my main board and I am confident in my abilities to replace the bad component once the circuit board is out but... not certain of the best way to get the main board out.
Any advice is appreciated.
Thanks