Hello
I have a NAD C370 amp and i like it a lot but, a couple off months ago it started to fail. When i turn it on, i only have sound from the left speaker. The right speaker only connects after 3 to 4 min.
Does anybody has a clue on this one?
Thanks
Mário
I have a NAD C370 amp and i like it a lot but, a couple off months ago it started to fail. When i turn it on, i only have sound from the left speaker. The right speaker only connects after 3 to 4 min.
Does anybody has a clue on this one?
Thanks
Mário
It could be a bad output relay. If you are using speaker A outputs, try moving the speaker wires to the B output posts. Select speaker B from the front panel and see if it still has a problem with the right channel.
Hey hello Bill
Thanks for your answer.
I´ve tried that but the problem is still the same. It cuts both right channels ( A and B outputs)
Does the protection circuit has anything to do with this? Is there any common failure in any component?
Thanks a lot
Mário
Thanks for your answer.
I´ve tried that but the problem is still the same. It cuts both right channels ( A and B outputs)
Does the protection circuit has anything to do with this? Is there any common failure in any component?
Thanks a lot
Mário
The protection circuit should affect both channels.
You can get a C370 service manual at ElektroTanya | Service manuals and repair tips for electronics experts
For protection circuit repair see pithed.org NAD C370 protection circuit repair (amp fails, goes into protection mode)
You can get a C370 service manual at ElektroTanya | Service manuals and repair tips for electronics experts
For protection circuit repair see pithed.org NAD C370 protection circuit repair (amp fails, goes into protection mode)
- Status
- Not open for further replies.