Dear all,
I'm going to receive an NAD 3020 Series 20 (the early version with a separate regulator board attached to the back panel) from the States. It's of course wired for 117V. I want to re-wire it to 220V. Any idea? I'm an amateur who can only handle simple soldering job.
Thank you for your kind help in advance.
Best regards,
mike
I'm going to receive an NAD 3020 Series 20 (the early version with a separate regulator board attached to the back panel) from the States. It's of course wired for 117V. I want to re-wire it to 220V. Any idea? I'm an amateur who can only handle simple soldering job.
Thank you for your kind help in advance.
Best regards,
mike
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.