My WM8741 x 4 with DSD Project

[naniking]

Hi,

I got a WM8741 x 4 DAC main board and I2S/DSD card.😀

Now, I want to connect them in hardware mode, so that it can decoding PCM / DSD file which is smoothly selection by footbar2000 🙂

 

[naniking]

ref. to wm8741 datasheet, in hardware mode.......

Pin 1, 2, 3, 5, 22, 27 are important source in.....

 

[naniking]

ref. to I2S/DSD card, the spec. which provide from manufactory.....

Technical parameters:

Input: USB2.0, high speed interface

output:
1) S / PDIF 75 ohm coaxial output
2) I2S

support sampling rates (PCM):
1) 44.1 KHz
2) 48 KHz
3) 88.2 KHz
4) 96 KHz
5) 176.4 KHz
6) 192 KHz
7) 352.8 KHz
8) 384 KHz

sampling rate support (DSD):
1 ) 2.8 MHz (DSD64) (DoP, ASIO native DSD)
2) 5.6 MHz (DSD128) (DoP, ASIO native DSD)
3) 11.2 MHz (DSD256) (ASIO native DSD)
4) 22.5 MHz (DSD512) (ASIO native DSD )

support digits:
1) 32 bit I2S output
2) 24 bit S / PDIF

output compatibility:
Mac OS 10.6 or above, Linux, Windows 32/64 WASAPI, ASIO, KS, DS drive

recommended player: Foobar2000 etc.

 

[naniking]

Beginning to connect both card, some idea need to consider.....

 

[naniking]

to be continuous.......

 

[lintweaker]

Hi,

Nice project. What USB I2S/DSD board are you using?

 

[naniking]

Hi,

Nice project. What USB I2S/DSD board are you using?

That is Tanly usb to dsd board, i'm bought it from china market.
Tanly

 

[lintweaker]

That is Tanly usb to dsd board, i'm bought it from china market.
Tanly

Thanks, found it!

 

[naniking]

hi hi, I'm come back....

Now, start from Tanly DSD USB board.........i can got the data output pins as shows on picture.

 

[naniking]

Double check with WM8741 datasheet.......

I found that must need those data input.....

Let's go..... try to connect them.... hope it is work.