MY UCD IRS2110 Sharing welcome

[ljm_ljm]

This is the forum Dublin University design. I learn and experiment a little,
Please share experiences, thanks.
Upload PCB GERBER document for your reference.

 

[johancraftech]

Thank you ljm_ljm, but a schematic will be help full.

 

[ljm_ljm]

Thank you ljm_ljm, but a schematic will be help full.

http://www.diyaudio.com/forums/class-d/166214-ucd-25-watts-1200-watts-using-2-mosfets.html

 

[darkfenriz]

Mosfets have their driver on virtually the opposite edge of a board??

 

[nigelwright7557]

Mosfets have their driver on virtually the opposite edge of a board??

A bit naughty, but my similar class d amp wasnt that fussy about layout or location of components.

Some of the class d chips are a bit more fussy about keeping tracks short and being well decoupled.

 

[ljm_ljm]

A bit naughty, but my similar class d amp wasnt that fussy about layout or location of components.

Some of the class d chips are a bit more fussy about keeping tracks short and being well decoupled.

Yes, this is a problem. But I was not too big desire to improve it.

Because it can not reach the frequency of my request.

 

[Hadighorbani]

This is the forum Dublin University design. I learn and experiment a little,
Please share experiences, thanks.
Upload PCB GERBER document for your reference.

Hi friend
meny thanks to you
can you send to me you PCB and shematic in PDF file please?
please send to me top and bottome layer.
me email adress is Hadi_ghr_e_61@hotmail.com
thanks

 

[norazmi]

if me, i`ll avoid by using LM311, try use something else. 😀

 

[nigelwright7557]

I used an LM393.

 

[Hadighorbani]

Please send to mr pcb and shematic
Thanks