Hi guys,
After a few weeks hard labour, finally my DIY Lenco project is finished.
It is based on a Lenco B51 and a Lenco L75.
I will post some pcs here, but the full project is discussed on my (non profit) website:
Audio Creative - hifi zelfbouw, versterkers, luidsprekers, hifi & muziek recensies
enjoy!
After a few weeks hard labour, finally my DIY Lenco project is finished.
It is based on a Lenco B51 and a Lenco L75.
I will post some pcs here, but the full project is discussed on my (non profit) website:
Audio Creative - hifi zelfbouw, versterkers, luidsprekers, hifi & muziek recensies
An externally hosted image should be here but it was not working when we last tested it.
An externally hosted image should be here but it was not working when we last tested it.
An externally hosted image should be here but it was not working when we last tested it.
enjoy!
Nice job dr.knibbeling!
I finished my heavy platter Lenco L75 build in December 2011. It is a 120v 60Hz model with five hole metal idler. I upgraded the platter bearing with a larger Mirko stainless steel spindle and housing. I thought I was considered an extremist as I cut the top plate😱 but I see someone stuck tubes in one.😀 The tone arm is an Advanced Analog MG-1 linear tracking/air bearing. Compressor is in basement and hose is run through a push lock bulkhead fitting in wall plate.
I finished my heavy platter Lenco L75 build in December 2011. It is a 120v 60Hz model with five hole metal idler. I upgraded the platter bearing with a larger Mirko stainless steel spindle and housing. I thought I was considered an extremist as I cut the top plate😱 but I see someone stuck tubes in one.😀 The tone arm is an Advanced Analog MG-1 linear tracking/air bearing. Compressor is in basement and hose is run through a push lock bulkhead fitting in wall plate.
- Status
- Not open for further replies.