Too bad you didn't bring those to Al's. They look pretty interesting....
All this full range fostex stuff makes me want to try another full range design on a bigger scale this time.
All this full range fostex stuff makes me want to try another full range design on a bigger scale this time.
Re: I'm crazy
Incredible. I have to get a CNC router😎 The brace looks good enough to be on the outside of the cabinet. And Tony, you're a Rembrandt with the vinyl😉layertone said:
wow, i didn't think this old topic would rise up again!
>Those cutouts won't fly away while you're cutting?
correct, they do not fly out or shift around. On .75 material, the programmed finish depth is .748 so a paper-thin material is holding the cutouts. Also this would retain the vacuum hold-down "seal" - my new cutting strategy; anyone else doing this?
>The brace looks good enough to be on the outside of the cabinet.
uh... i just made up that brace
>In the RonHorn A126 their performance is quite stellar.... still a work in progress.
Ron's A126e would be a nice next project... going off on a tangent now revisiting my R/C hobbies
>Those cutouts won't fly away while you're cutting?
correct, they do not fly out or shift around. On .75 material, the programmed finish depth is .748 so a paper-thin material is holding the cutouts. Also this would retain the vacuum hold-down "seal" - my new cutting strategy; anyone else doing this?
>The brace looks good enough to be on the outside of the cabinet.
uh... i just made up that brace
>In the RonHorn A126 their performance is quite stellar.... still a work in progress.
Ron's A126e would be a nice next project... going off on a tangent now revisiting my R/C hobbies
- Status
- Not open for further replies.