JOE DIRT® said:
Don't worry, I've found that prehensile toes come in handy when there isn't a friend to help with assembly. 😉
SRMC
this is the the amp and driver I`ll be using for the sub in the house powered off my 4 interstate Gel cell marine Batteries.....a Big thanks to PDQ for doing the board for me and to the powder coaters for the heat sink.....amplifier out put is 400 watts into 4 ohms bridged and will be incorperated into the cabinet similar to a plate amp
Attachments
What exactly are you building? From the pics above it looks like you've got two transformers and some sizeable caps. Is one for your sub and the other for your main speakers?
SRMC
SRMC
I`m building a few amps for my home vidieo system.......sorry I never made it clear...as I was lent the camera and went crazy today.....the Lm3886`s are going to be for the centre channel set up....the STK`s will be for the rear and side fill ....and the main amp will power my main speakers....I am Bi-amping the main speakers I`m building....my pic that is shown is actually for two amplifiers for them.....the sub will be on its own setup as mentioned...its all in prelimenary stages right now and I will post some more as it gets finished......I have plans on utilising a pic controller for my preamp for selection of source and active crossovers...its an on going project and as always work comes first
DIRT®
DIRT®
- Status
- Not open for further replies.