Mono buffer for Purifi 1ET7040SA

As requested the 1et400s buffer for the 1et7040sa.

1689522832789.png


1ET7040SA Monobuffer PCB.jpg


3d 1ET7040SA PCB.jpg


With below the gerberfiles.
 

Attachments

Last edited:

Attachments

  • 20230715_224633.jpg
    20230715_224633.jpg
    544.3 KB · Views: 174
  • 20230715_224621.jpg
    20230715_224621.jpg
    598.8 KB · Views: 185
  • 20230715_224639.jpg
    20230715_224639.jpg
    285.1 KB · Views: 181
  • Like
Reactions: wyup and Koifarm
Hello -
I have a couple of questions about the buffer, or driving the 1ET400A modules. I plan on using the SMPS1200A400 power supply. My question is, if I have a fully differential preamplifier with the required amount of voltage drive, what is required from the buffer board to properly connect up to the 1ET400A modules? What's the purpose of the +/-15V supply? If I were to make a PCB with just the XLR input, and multi-pin docking connector H1, along with H2, what are the required pins for connection? I'm looking for a "minimalist" type of connection to drive it with my LS17 preamp without too much between!

Thanks for your help.