Here is a DIY Modulus 86 amplifier with dual mono SMPS power supplies. The boards, and inductors were all purchased from Tom's website, the chassis is a Modushop Dissipante and the rest DigiKey/Mouser. The amp sounds great! See Tom's site for more info: https://neurochrome.com/products/modulus-86
Asking $400 to your door in CONUS
NOTE: The hole on the IEC and power switch are elongated since I mis-measured the height! 🤦♂️
Asking $400 to your door in CONUS
NOTE: The hole on the IEC and power switch are elongated since I mis-measured the height! 🤦♂️
Attachments
Cool! Looks like a Rev. 2.4 powered by an SMPS-86. Very nice. It's a little unfortunate with the mishap on the rear panel. If that really bothers someone, they could always get a new panel from ModuShop.
Tom
Tom
I bet you could replace it with a panel mount version and extend your wires. That would cover up the gaps.
I’m sure the buyer could easily make the change if it bothered them. Nice looking amp! GLWTS
I’m sure the buyer could easily make the change if it bothered them. Nice looking amp! GLWTS
