Does anyone out there have any information on modifying the output filter of a TC2000/TP2050 Tripath amp for a resistive 2ohm load.
I want to run a set of Carver ribbon drivers with Tripath amps.
These ribbons are VERY efficient, so I only need about 5W per ribbon.
But I would still like to have the amps tuned for that load for best sound.
I want to run a set of Carver ribbon drivers with Tripath amps.
These ribbons are VERY efficient, so I only need about 5W per ribbon.
But I would still like to have the amps tuned for that load for best sound.