Hi all!
This is my first topic on this site.
I am looking for advice and instructions where to start tweaking a NAD C356BEE amplifier.
I have expiriece with electronics, but not in Audio.
There will be no problem with soldering and understanding schematics.
Interested to get your suggestions or experience with this particular amplifier.
I can send some pictures or SM (Service Manual)
This is my first topic on this site.
I am looking for advice and instructions where to start tweaking a NAD C356BEE amplifier.
I have expiriece with electronics, but not in Audio.
There will be no problem with soldering and understanding schematics.
Interested to get your suggestions or experience with this particular amplifier.
I can send some pictures or SM (Service Manual)
I was thinking about removing tone circuit and balance potentiometer.
It looks that we have 2 preamps (PREAMP1>VOLUME AND TONE CONTROLL>PREAMP2).
Cables used for signal transport are extremly thin.
I measured some capacitors from Power Supply. Some of them have ESR between 0,1 - 0,2 Ohm. Dont know that replacing them will change something.
CR Filter. I could replace 10uF electrolyte with 2.2uF or 3.3uF film capacitor.
Would be great to hear some opinions about this changes.
It looks that we have 2 preamps (PREAMP1>VOLUME AND TONE CONTROLL>PREAMP2).
Cables used for signal transport are extremly thin.
I measured some capacitors from Power Supply. Some of them have ESR between 0,1 - 0,2 Ohm. Dont know that replacing them will change something.
CR Filter. I could replace 10uF electrolyte with 2.2uF or 3.3uF film capacitor.
Would be great to hear some opinions about this changes.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.