mmats 3000.1

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Jump to Latest
I

imraneesa

Member
Joined 2016
HI all,

I got this amp. after replacing all the output fets and IRS21844S IC the amp came on normal. but just after some time. idle current gone too low and SG3525 duty cycle gone too low. i measured voltages and pin1 is 5v and pin2 is 5.1. somebody interfered with the resistor R37 and when measured it was 56k. i am getting voltage on pin9 0.6~0.9v.

green led lits dim and amp remains lower than 0.3amps. sometimes 0amps.

i tried to change the resistor value as 62k ohms then amp goes into protect.
 
Last edited:
I

imraneesa

Member
Joined 2016
Perry Babin said:
If no one has a definitive answer, post good quality photos of the main board and another one of the power supply control circuit.
Click to expand...
Here are the pictures.
 

Attachments

  • 20191103_004912.jpg
    20191103_004912.jpg
    991.9 KB · Views: 112
  • 20191103_004838.jpg
    20191103_004838.jpg
    967.6 KB · Views: 107
I

imraneesa

Member
Joined 2016
Perry Babin said:
That's essentially the same as the 4080 amps. Are all of the supply and input voltages on the 3525 remaining OK when the voltage on pin 9 drops?

If you 're getting essentially the same voltage on pins 1 and 2, the duty cycle is OK because the rail voltage is present.
Click to expand...
I am having all the voltages on 3525. If duty cycle is ok then why is it not pulling no current. What am I missing?
 
I

imraneesa

Member
Joined 2016
Perry Babin said:
I think 7v is about right for the positive power supply pin.

I think it's very similar to the 4080 mmats amps which is similar to the 4080 Earthquake amps. See attached if you don't already have something similar.
Click to expand...
Eventhough there is voltage on 3525 pin1 pin2 and 0.9v on pin9 there is no voltage on output pins of 3525. Rail voltage may be generating at the starting but then 3525 is not sending pulses.
 
I

imraneesa

Member
Joined 2016
Perry Babin said:
The regulators that you referred to here:
Also this amp has LM340T 15v 7815 regulator.

Is the output stage completely intact?
Click to expand...
Only one regulator it have. "Lm340t15". 7815 written on it also. And I changed this to see if it was giving trouble. The output section mainly the driver card was removed by some other tech and he spoiled the vias. But when I first on the amp the waveform all look perfect. Then I dont know if any intermittent bad connection exit.
 

Attachments

  • 20191101_123424.jpg
    20191101_123424.jpg
    781 KB · Views: 48
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Top Bottom