MLTL 206 Filter components

[zotar]

Trying to fine tune my MK MLTL Fostex 206, I now using Madisound Sledgehammer 3.0mH inductor, would the perfect lay type or Goertz type be an improvement? Using a Multicap 4.0uf film and aluminum cap, any suggestions? Tried a 3.0 Hovland and Auricap. A 4.5 ohm parallel resistor seems to give me the best balance. Thanks in advance.

 

[zygibajt]

Hi,

I'm using FE 204 which is the older brother of FE 206, and is quite similar in parameters.
I got best results with 10ohm resistor, 4mH coil and 2uF cap.

Bartek

 

[Toropkin]

I got best results with 10ohm resistor, 1mH coil and 2,42uF cap
in parallel.

Driver - FE-206

 

[weidok]

Trying to fine tune my MK MLTL Fostex 206, I now using Madisound Sledgehammer 3.0mH inductor, would the perfect lay type or Goertz type be an improvement? Using a Multicap 4.0uf film and aluminum cap, any suggestions? Tried a 3.0 Hovland and Auricap. A 4.5 ohm parallel resistor seems to give me the best balance. Thanks in advance.

I am using 1,8 mH and 8 ohm in a ML TL wih the FE 167 E
no caps at all !!!!

Do you have pictures and drawings of the enclosure

 

[Toropkin]

Re: Re: MLTL 206 Filter components

I am using 1,8 mH and 8 ohm in a ML TL wih the FE 167 E
no caps at all !!!!

Do you have pictures and drawings of the enclosure

Please:

http://www.metaleater.narod.ru/ls2061.jpg
http://www.metaleater.narod.ru/ls2060.jpg
http://www.metaleater.narod.ru/ls206.jpg

- my system

Original blueprinting:

http://www.sloejd-kbh.dk/tema/speakers/jeriko/jeriko.htm

 

[zotar]

Fostex 206E

The cabinet plans can be found at Martin King's MLTL website. I am surprised at the difference in filter network components being used by the readers. I started with the recommended filter by M.King and modified it slightly. Are you guys using the same cabinet parameters?