Hello.
I don't know if this is the proper forum, but let's try:
I do have a stack with 1 miniDIGI board + 2 MminiDSP balanced connected following the Application Note "Configuration of 1 miniDIGI + 2 miniDSP" to buils a 4 way crossover
What I need to confirm is the Jumper Chart for 1 miniDIGI + 2x miniDSP stack because i think thet the one ath miniDSP web is wrong or, at least not the proper one for my application.
this is what I did:
Minidsp 1 (left CH) SLAVE
Minidsp 2 (right CH) SLAVE
Minidigi MASTER
Does I have to setup J1 at miniDIGI like a 2 way setup??
Picture might not be cclear, but the miniDIGI setup is like MASTER
I don't know if this is the proper forum, but let's try:
I do have a stack with 1 miniDIGI board + 2 MminiDSP balanced connected following the Application Note "Configuration of 1 miniDIGI + 2 miniDSP" to buils a 4 way crossover
What I need to confirm is the Jumper Chart for 1 miniDIGI + 2x miniDSP stack because i think thet the one ath miniDSP web is wrong or, at least not the proper one for my application.
this is what I did:
Minidsp 1 (left CH) SLAVE
Minidsp 2 (right CH) SLAVE
Minidigi MASTER
Does I have to setup J1 at miniDIGI like a 2 way setup??
An externally hosted image should be here but it was not working when we last tested it.
Picture might not be cclear, but the miniDIGI setup is like MASTER