• The swap meet forum is for private non-commercial transactions. Only unmoderated members can post here.

    diyAudio provides this forum for the convenience of our members, but makes no warranty nor assumes any responsibility. We do not vet any members. Use of this facility is at your own risk. Customers can post any issues in those threads as long as it is done in a civil manner. All diyAudio rules about conduct apply and will be enforced.

Mini "sale" on APOX system

Status
Not open for further replies.
I have one APOX-1 and two APOX-2's that have been built and tested.

The APOX-1 is built using a "5K" set of BC 1% MF resistors.

The APOX-2's are a -40 -> 0 dB 5K series (All but one resistor is H8 0.1%) .

They will be offered free with the new purchase of an IR1.

You could always de-solder the resistors.

Best Regards,

Dale

P.S. These board were used to test out our software.
 
Hi Arne,

Sounds good. We will order more IS1 boards on Monday. I will put a rush on these.

Did you see my email regarding the 50K on your APOX-1 resistors?

The additional amount would be $225.00.

The APOX-2 will do one channel balanced and two channels single ended. Just want to make sure!

Best Regards,

Dale
 
Status
Not open for further replies.