Hi, I would like to build a design based around the Pultec MEQ5 EQ but am not very electronically minded. I want to add some mid-cut at 1,2,3,4 Khz. Could someone tell me what the combo L & C values need to be at these freqs? Is it straightforward to calculate them? I have seen the MEQ5 schematic but couldn't figure it out! Doh! Thanks in advance
Hi,
Download tina ti free circuit sim and check that it works.
(stick an op-amp in the corner unconnected to get it to work, then
use AC analysis to plot the frequency reponse, quick and easy)
600R is a fairly hefty load for an output - can the equipment
drive 600 ohm loads ?
/sreten.
Download tina ti free circuit sim and check that it works.
(stick an op-amp in the corner unconnected to get it to work, then
use AC analysis to plot the frequency reponse, quick and easy)
600R is a fairly hefty load for an output - can the equipment
drive 600 ohm loads ?
/sreten.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Design & Build
- Parts
- Midrange tone control