Measuring CCS impedance and at different frequencys

Status
Not open for further replies.
Jump to Latest
K

Kevinbd

Member
Joined 2002
#1
Hello,

1,

I am trying to measuring the impedance of some current sources at various frequency's.

Can someone tell me how to do this ?

2,

PS. Does anyone know a good way to cascode mosfets for a current source?

Have seen this done with jfets but have to use mosfets for higher voltage.

Thanks
 
#2
As for 1 for small currents you could usa a OPAMP to drive a voltage at the out put of the current source.

Connect currentsource resistor and opamp.

Vary the voltage on the opamp output with the desired frequency and measure the voltage swing on the output of the currentsource and the varying current you measure over the resistor. The output resistance is the Voltage swing on the current source/current through resistor.

2:
You need a second voltage reference for the cascoded mosfet. Place it so that the Vref-Vgs is higher than the output of your current generator.
 
Status
Not open for further replies.
Top Bottom