well...i am pretty new to this hobby...so a while back i bought a couple of the mcm 55-1870 full ragne speakers...i built some pretty ugly cabinets for them (ugly becayse they looked odd...too slim and too tall...but would look odd on stands...) and have since taken the drivers out because i knew i could do much better with them...
sooooo... any ideas on what i should do? i haven't found too many projects that use this driver...and nothing TOO complicated...i am a noobie🙄
sooooo... any ideas on what i should do? i haven't found too many projects that use this driver...and nothing TOO complicated...i am a noobie🙄
well?
ANY iedas?
just show me what to build and i'll build it
i have all kinds of fun power tools...we have a shopsmith
ANY iedas?
just show me what to build and i'll build it
i have all kinds of fun power tools...we have a shopsmith
well go grab your favorite speaker design program, enter the T/S parameters and see what it comes up with.
I use WinISD by Linearteam - but there are many others out there.
And im jealous of your shopsmith
I use WinISD by Linearteam - but there are many others out there.
And im jealous of your shopsmith
😀 the shopsmith IS very cool...it has a laithe atatchment...si i could build some pretty awsome stuff with that once i have enought practice...
it was pretty scary to use at first (its an older model...)
also.... can i have a link explaning what all this stuff means? i am pretty new to this...and a bit retarded <-----this smily is laughing and yelling "yyyyyaaaaaaaayyyyy" whilst hitting a board with no nails....🙂 ...can't forget the drool🙂
it was pretty scary to use at first (its an older model...)
also.... can i have a link explaning what all this stuff means? i am pretty new to this...and a bit retarded
<-----this smily is laughing and yelling "yyyyyaaaaaaaayyyyy" whilst hitting a board with no nails....🙂 ...can't forget the drool🙂- Status
- Not open for further replies.