I've seen this tweeter around and especially on ebay. Does anyone know of this tweeter, it's specs and how it performs? All reviews are welcomed 😀
Hello,
MCD 25 is a Titan tweeter from MB Quart Germany.
QMS 3,45
Qes 2,85
Qts 1,56
Xmax 0,9mm
Sd 4,9 qcm
Re 7,1Ohm
LE 0,04mH
Fms 930 HZ
92db 2,83Volt
Max 100 Watt
8 Ohm
480Gramm
Voice Coil 25mm
3mm high
Greetings from Germany
Jochen Sonnenschein 😎
MCD 25 is a Titan tweeter from MB Quart Germany.
QMS 3,45
Qes 2,85
Qts 1,56
Xmax 0,9mm
Sd 4,9 qcm
Re 7,1Ohm
LE 0,04mH
Fms 930 HZ
92db 2,83Volt
Max 100 Watt
8 Ohm
480Gramm
Voice Coil 25mm
3mm high
Greetings from Germany
Jochen Sonnenschein 😎
Rather Excellent Tweeter
Hello,
I plan to make a new crossover for an MB Quart driver compliment. It belonged to an MB Quart speaker (2X6.5'' + MCD 25). The cabinet has already been made again DIY (the same size), but with very steardy construction and excellent looks. The main reason we wanted to remake the speaker was the tweeter. It sounds excellent. If my memory serves me right must have seen it on Aerial Acoustics flagship 8 years ago. Maybe modified though. Well worth purchasing. For how much is it offered?
Hello,
I plan to make a new crossover for an MB Quart driver compliment. It belonged to an MB Quart speaker (2X6.5'' + MCD 25). The cabinet has already been made again DIY (the same size), but with very steardy construction and excellent looks. The main reason we wanted to remake the speaker was the tweeter. It sounds excellent. If my memory serves me right must have seen it on Aerial Acoustics flagship 8 years ago. Maybe modified though. Well worth purchasing. For how much is it offered?
Yes those specs do looks rather nice. Nothing bad to say about them, its got a very nice xmax, although its fs isnt remarkable if suppressed this tweet could probably handle its fair share of low xovers.
The double magnet version was added to the MB product line, after testing the custom version they were building for Avalon Acoustics.
They are very good tweeters.
They are very good tweeters.
I guess i should of also told you'll i want to run it for highs in my car 🙄 . Im guessing it should work the same way. what you'll think? If it isnt good, i saw the Morel MDT-20 and would buy that instead. But is that morel tweeter worth the $53 ?
Just note that the Qts of 1.56 tells me you have to careful and
take this into account when designing the crossover.
There is also likely to be a high impedance peak at resonance.
However if you pad it down for level matching using a series /
parallel resistor combination the parallel resistance will suppress
the impedance peak.
But not the frequency response peak due to Qts.
🙂 sreten.
take this into account when designing the crossover.
There is also likely to be a high impedance peak at resonance.
However if you pad it down for level matching using a series /
parallel resistor combination the parallel resistance will suppress
the impedance peak.
But not the frequency response peak due to Qts.
🙂 sreten.
- Status
- Not open for further replies.