What is the best way of matching the MOSFET transistors?
1 by measuring the voltage of the generator to the source or
2 mA measuring current
1 by measuring the voltage of the generator to the source or
2 mA measuring current
I would measure the voltage at which they switch on.
You could this with a LED in series with a resistor as a load then monitor the gate voltage.
You could this with a LED in series with a resistor as a load then monitor the gate voltage.
IRF 610 matching
What is the best way of matching the IRF 610 and which are the most critical
the input or output or the source.
I measure the milliamps or volts and the brand has to be IR.
The input and output 5ma 20 ma, has to be strict, because
I find them accurate.
a greeting
What is the best way of matching the IRF 610 and which are the most critical
the input or output or the source.
I measure the milliamps or volts and the brand has to be IR.
The input and output 5ma 20 ma, has to be strict, because
I find them accurate.
a greeting
- Status
- Not open for further replies.