Hi guys, I am one of the old Lumenlabs guys, and haven't worked on my projector in roughly 3 years now! It's in a state of 99% completion, but just never got the last little bit of fine tuning...
After all this time I'd now like to get it all finished and 100% working and hooked up, but im finding it very hard to remember whats been done. Is it possible in any way to get all the information form my old plog (projector blog) back so i can post it on here?
Basically all i need to fix on it is the unfocused edges that run around the edges about roughly 1/3rd of the picture, fine for watching movies, but terrible for font, gaming etc.
I hope someone can help!
After all this time I'd now like to get it all finished and 100% working and hooked up, but im finding it very hard to remember whats been done. Is it possible in any way to get all the information form my old plog (projector blog) back so i can post it on here?
Basically all i need to fix on it is the unfocused edges that run around the edges about roughly 1/3rd of the picture, fine for watching movies, but terrible for font, gaming etc.
I hope someone can help!
Lumenlab is dead and gone so there is no way to get your plog info. We are still here at DIYProjectorkits.com if you want to stop by and see if we can help you.
Not all of my forums are pay, if you notice I have no ads on my site and the $20.00 fee barely helps pay for the site if at all.
- Status
- Not open for further replies.