I have used exactly the same circuit with good results. With -24 volts the IXYS chip works good. A slight improvement may be noted with much higher voltages.
If you have less voltage and only need 10mA, check out the National LM334. I have used that one with a - 7 volt supply (rectified 6.3 V). It is only good to 40 volts max, 10 mA max.
If you have less voltage and only need 10mA, check out the National LM334. I have used that one with a - 7 volt supply (rectified 6.3 V). It is only good to 40 volts max, 10 mA max.
Has anybody used the 1N5283-1N5314 current regulator diode range? I use a 3.9mA and a 4.3mA parallel, supplied from the -50V bias voltage and they work fine.
On second look: Only 2 mA... Performance may be marginal with the IXYS chip. Try the 2 transistor LED-biased CCS in the Baby Huey thread.
tubelab.com said:
I'd like to feed 8mA into a 12AV7 LTP, and I also plan on rectifying a 6.3V heater winding. Could you explain how to calculate/wire a LM334 to work? I'm a bit clueless unfortunately..
Go to www.national.com and insert LM334 into the search box. The product page will show up. There are two circuits shown, you want the simple one on the right. Yeah, just a resistor and the chip. For 8 mA the resistor will be about 10 ohms. Connect the bottom terminal (V-) to your negative voltage source. and the top terminal (V+) to the 12AV7 cathodes. This chip will function with less than a volt so you may get by without a negative voltage (ground the V- terminal) although I have found that the chip likes some headroom. Rectified 6.3V is fine. Don't use over -35 volts.
Morgan Jones uses this chip in some of his designs and it is mentioned in the third edition but I am not at home now, so I don't know the page numbers.
http://www.national.com/mpf/LM/LM334.html
Morgan Jones uses this chip in some of his designs and it is mentioned in the third edition but I am not at home now, so I don't know the page numbers.
http://www.national.com/mpf/LM/LM334.html
- Status
- Not open for further replies.