LspCAD question

[ksporry]

I am using LspCAD6 to construct a crossover. I don't know how. The manual only state WHAT the functions are, not how to use it. Teh tutorial does not describe anything, so I click e afew functions. No idea what they do and why I click them or what efefct it has. The documentation is absolutely appauling.
hence I come to this forum in the hope someone can guide me through the process. I can put components on teh drawing. I can change some values of resistors and capactors and inductors, how do I assign driver details to teh driver?
I know I can import driver details (unt files) but they get imported in a separate component that is not even connected to the schematic. How does this all work?
Help please? pretty please?

 

[Henkjan]

what is a short term solution: use LspCAD5.25, it is bundled with 6, a lot easier to use.

 

[aczern]

ksporry
"I can put components on teh drawing. I can change some values of resistors and capactors and inductors, how do I assign driver details to teh driver?"

You must to switch to 'Simulate'

 

[aczern]

Clic on driver then open window as on picture

 

[aczern]

If you have files with the SPL and impedance with names *.FRD and *.ZMA need to change *.txt

 

[ksporry]

Now I can draw a schematic. Butvhow so I construct an enclosure and combine it with the crossover schematic. Likewise, if I use 3 separate filters for each driver, how do I see the total effect?