Hi,
I don't think this topic has been covered before. On my previous X150.5 amplifier I was able to locate and change the gain jumpers to get 6dB extra gain out of my amp. I now have a 2nd hand XA30.8 and I need to do the same thing so I lifted the lid and had a look around but I can't see anything similar on the top board that resembles the jumpers on the older designs.
Has anyone located them on the .8 models? I am guess Mr Pass might have an idea of where they are
Also, while I'm at it, I have a Primare Preamp that has a 12V trigger but it is on the TS / 3.5mm headphone type rather than banana plugs that are on the XA30.8.
I didn't get a cable with the preamp so I am guessing a mono TS cable will work and I can simply pull the end apart for form a negative and positive?
I don't think this topic has been covered before. On my previous X150.5 amplifier I was able to locate and change the gain jumpers to get 6dB extra gain out of my amp. I now have a 2nd hand XA30.8 and I need to do the same thing so I lifted the lid and had a look around but I can't see anything similar on the top board that resembles the jumpers on the older designs.
Has anyone located them on the .8 models? I am guess Mr Pass might have an idea of where they are
Also, while I'm at it, I have a Primare Preamp that has a 12V trigger but it is on the TS / 3.5mm headphone type rather than banana plugs that are on the XA30.8.
I didn't get a cable with the preamp so I am guessing a mono TS cable will work and I can simply pull the end apart for form a negative and positive?
if Pa or Wayne does not chime in , just write to PL directly
I tried to PM him but his account is set to not accept messages
go to Pass Labs | Products that invite you to listen
click on "my pass" , upper right corner
or to make it easier for ya , write to >service@passlabs.com<
click on "my pass" , upper right corner
or to make it easier for ya , write to >service@passlabs.com<
Odd, I looked at all examples of artwork and they have them, clearly marked.
Nelson thanks for that. Not being an EE, I don't know what you mean by Artwork - if you are referring to circuit drawings then I would lost looking at them!
I'll email you guys directly about this. Perhaps diyAudio was not the best place to direct my question
If you are in melbourne I could have a look at the circuit board for you
Thanks for the offer but I'm not in Melbourne.
Anyway shouldn't you be at the Grand Final parade?
I've shot an email off to PL to see what they come back with.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Amplifiers
- Pass Labs
- location of gain jumpers in XA30.8