I am using the Natsemi LM4562 spice model (LME49860) and I am getting 19ppm distortion, no matter what the output signal or load.
Has anyone else picked this problem up? Maybe one of the National semi guys on the forum can comment.
I have measured this op-amp with an AP SYS2722 and it does perform as it says in the data sheet. But not the spice model for some reason.
Has anyone else picked this problem up? Maybe one of the National semi guys on the forum can comment.
I have measured this op-amp with an AP SYS2722 and it does perform as it says in the data sheet. But not the spice model for some reason.