Okay!
So, i'm building my first completley-from-scratch pre-amp (have only modified amps before), and i will build in a Buffalo-dac and all that completely. Now before i drill the bottom for the PCB-standoffs i thought i would ask what you people think about the layout.
Why i ask, is because it wouldn't be THAT fun drilling alot of holes in the bottom of the case and the the layout is bad and i get alot of hum.
So here you can find a picture of the design:
LINK
Red wires is AC, Blue is DC and Green is signal. I also have wrote above all components what they are.
The transformers/AC-filter will be covered by a aluminum housing.
I have tried putting the AC in the middle, to get all AC as "collected" as i possibly can.
Any comments about the layout will make me glad 🙂
So, i'm building my first completley-from-scratch pre-amp (have only modified amps before), and i will build in a Buffalo-dac and all that completely. Now before i drill the bottom for the PCB-standoffs i thought i would ask what you people think about the layout.
Why i ask, is because it wouldn't be THAT fun drilling alot of holes in the bottom of the case and the the layout is bad and i get alot of hum.
So here you can find a picture of the design:
LINK
Red wires is AC, Blue is DC and Green is signal. I also have wrote above all components what they are.
The transformers/AC-filter will be covered by a aluminum housing.
I have tried putting the AC in the middle, to get all AC as "collected" as i possibly can.
Any comments about the layout will make me glad 🙂