Ahh, I see. Well you could still use Legato, but the BAL/SE stage you would want to completely omit.
Only it's necessary the input bias to 0V (or close)?
It's not necessary ground the input - (cold)?
No need to change some resistor CCS & I/V?
It's not necessary ground the input - (cold)?
No need to change some resistor CCS & I/V?
Last edited:
I would have to look at the datasheet. I simply don't have time at the moment. If you grounded one end (-end is fine) then it should work, but it would definitely not be ideal. Your going to have to research this yourself for the moment.
Thank you, only one question more: wich are CCS Rs (R6-R8) & I/V Rs (R21-R24)?
R20,R21 R23,R24 are CCS
R1-R4 are I/V
I would have to look at the datasheet. I simply don't have time at the moment. If you grounded one end (-end is fine) then it should work, but it would definitely not be ideal. Your going to have to research this yourself for the moment.
If I understod correctly I grounded the Legato input negative to ground & used only the balanced output GND & +, that's correct?
Merlin, your just going to have to figure this one out on your own. I don't have that DAC to test nor do I really have any interest in it. I am guessing you will simply want to setup the Legato for about 4X its normal current to voltage ratio. Refer to the manual on that.
- Status
- Not open for further replies.
- Home
- More Vendors...
- Twisted Pear
- Legato for PCM1704