Hey Guys,
I write today beacuse of newfound motivation to jumpstart my leach amp project. (new boards, new parts, commitment, oh and a access to a good soldering iron)
Just a basic question, where and how would I add a volume control into the Leach Amp? I only want one control that raises and loweres volume equally on both channels, and I've been trying to use my limited knowledge of circuiting to figure this out, but I really am no farther from where I started this morning.
I'm no EE guys, so the more specific the better.
Thanks for the wisdom.
Brian
I write today beacuse of newfound motivation to jumpstart my leach amp project. (new boards, new parts, commitment, oh and a access to a good soldering iron)
Just a basic question, where and how would I add a volume control into the Leach Amp? I only want one control that raises and loweres volume equally on both channels, and I've been trying to use my limited knowledge of circuiting to figure this out, but I really am no farther from where I started this morning.
I'm no EE guys, so the more specific the better.
Thanks for the wisdom.
Brian
How about a dual POT. Go down to the local Radio Shack and take a look at what they have. It's two pots with a common shaft. Just what you need.
Later BZ
Later BZ
- Status
- Not open for further replies.