Hi Col,
Our plots are the original plots of the genuine Lateral Mosfet Amplifier, done on our own AP analyser. The others are not plots of that amplifiers shown.
Regards
Our plots are the original plots of the genuine Lateral Mosfet Amplifier, done on our own AP analyser. The others are not plots of that amplifiers shown.
Regards
tritosine said:
we are now manufacturing a new updated batch ready end of september will send you tim/imd then
Is an updated & informative datasheet available for these lateral mosfets? I would be interested in seeing it as I'm interested in buying some of these - could somebody email it to me?
Are the class-d lateral mosfets designed to operate cooler than the 2SK1058 and 2SJ162? Currently an amplifier project for home theater is being built using the listed devices. Heatsink area is a concern for the number of amps to be incorporated into the case. Feedback would be appreciated.
John
John
If they have lower on resistance than the Hitachis (which is possible as 12A max current is suggested) then you will get a little bit more output power for the same rail voltages.
The power dissipation will not change much though as a class AB amplifier playing music spends most of its time at low output power. Idle current, rail voltage and load impedance is what matters.
The "data sheet" provided is very inconcistent though. How does 150 degree Tj max, 125W Pd max and 1.6 degree/watt Rthj-c add up?
Avnet has a good price on the Hitachis.
The power dissipation will not change much though as a class AB amplifier playing music spends most of its time at low output power. Idle current, rail voltage and load impedance is what matters.
The "data sheet" provided is very inconcistent though. How does 150 degree Tj max, 125W Pd max and 1.6 degree/watt Rthj-c add up?
Avnet has a good price on the Hitachis.
I tried AVnet & as somebody here cleverly said it should be called "Havenot".
My experience wasn't good with them - I think the consensus is that unless you are a large company they don't want to know.
I ordered 10 2SK1058s but because my delivery address was different to my billing address I got an email to confirm that I was not selling these on. Fair enough - I answered it. No reply for 8 days after a lot of emails to them to find out what the status on the order was.
They also added an extra $20 onto my order that I was not aware of at time of order & only spotted when I reread their only email to me. I finally cancelled my order & queried the $20. They quickly replied to my cancellation, thanking me (as if they were glad of it) & said that the $20 was for if shipping charges were more than anticipated!
Seems very unprofessional to me!
Edit: I agree with the opinion on ClassD though - I have asked them for a proper datasheet on their mosfets but got none. In another thread a user of these mosfets replied that they were good - more powerful than the 2SK1058 but not as sweet.
My experience wasn't good with them - I think the consensus is that unless you are a large company they don't want to know.
I ordered 10 2SK1058s but because my delivery address was different to my billing address I got an email to confirm that I was not selling these on. Fair enough - I answered it. No reply for 8 days after a lot of emails to them to find out what the status on the order was.
They also added an extra $20 onto my order that I was not aware of at time of order & only spotted when I reread their only email to me. I finally cancelled my order & queried the $20. They quickly replied to my cancellation, thanking me (as if they were glad of it) & said that the $20 was for if shipping charges were more than anticipated!
Seems very unprofessional to me!
Edit: I agree with the opinion on ClassD though - I have asked them for a proper datasheet on their mosfets but got none. In another thread a user of these mosfets replied that they were good - more powerful than the 2SK1058 but not as sweet.
How similar are these Class-D brand FETs to Magnatec BUZ901P/BUZ906P?
Are they the same? Similar in any way? Bigger die?
Are they the same? Similar in any way? Bigger die?
Update: I was contacted by Class-D & they are sending me over some Mosfets to "play with". Good response from them, I reckon.
Had a good chat with Mike from Class-D (he's the amplifier man there) & he struck me as a knowledgeable & friendly guy. They have some interesting products being launched between now & christmas but I won't steal their thunder. One thing he did say which I can tell is that they have removed the in-built zener from the mosfet to prevent oscillations.
Now I don't have much experience with laterals so I'll be comparing them sound-wise to some Fairchild FQA34N20 mosfets in a source follower Susan Parker Zeus amp. It will take a while though.
Had a good chat with Mike from Class-D (he's the amplifier man there) & he struck me as a knowledgeable & friendly guy. They have some interesting products being launched between now & christmas but I won't steal their thunder. One thing he did say which I can tell is that they have removed the in-built zener from the mosfet to prevent oscillations.
Now I don't have much experience with laterals so I'll be comparing them sound-wise to some Fairchild FQA34N20 mosfets in a source follower Susan Parker Zeus amp. It will take a while though.
Mike Soppelsa
I hope you are still following this thread.
I have received your initial e-mail and wrote you twice regarding potential opportunities you may be interested.
However, I got no replies and assumed that my messages may be in your junk mail by mistake.
I look forward to receiving the samples for evaluation.
Best regards,
LS
I hope you are still following this thread.
I have received your initial e-mail and wrote you twice regarding potential opportunities you may be interested.
However, I got no replies and assumed that my messages may be in your junk mail by mistake.
I look forward to receiving the samples for evaluation.
Best regards,
LS
Hey guys,
Sorry I haven't reported back but my amp building has ceased for the moment while my back recovers from a sciatic nerve problem I aggravated while carrying an oscilloscope.
Normally this would clear up in a number of days but not this time - it's been 2 weeks & stll have pins & needles down my leg & in my foot.
Sorry I haven't reported back but my amp building has ceased for the moment while my back recovers from a sciatic nerve problem I aggravated while carrying an oscilloscope.
Normally this would clear up in a number of days but not this time - it's been 2 weeks & stll have pins & needles down my leg & in my foot.
Hope you success
Thank you Class D
Thank you Mike Soppelsa
Hope you success too in your bussiness
Best Regards,
Jeffry Widjaja
Thank you Class D
Thank you Mike Soppelsa
Hope you success too in your bussiness
Best Regards,
Jeffry Widjaja
Powerful digital audio amplifier cheap (IC)
I would like to use IC (chip) in the pcb for digital audio amplifier which work
with net 220V/ = 90V-160 V (160 V preferable). Output power is 500W - and more.
We need IC digital power amplifier like Tripach TA 0104A (500W) but more powerful up to 1000W - 5000W.
We can use little pcb with same parameters.
So try offer audio digital amplifier IC up to 20 kHz with power supply around 90-160V and output power up to 5000W.
Pls. Senf PDF information for study.
Brgds, Ms. Olga, Ukraine
can you write me on address
<olzon@rambler.ru>
I would like to use IC (chip) in the pcb for digital audio amplifier which work
with net 220V/ = 90V-160 V (160 V preferable). Output power is 500W - and more.
We need IC digital power amplifier like Tripach TA 0104A (500W) but more powerful up to 1000W - 5000W.
We can use little pcb with same parameters.
So try offer audio digital amplifier IC up to 20 kHz with power supply around 90-160V and output power up to 5000W.
Pls. Senf PDF information for study.
Brgds, Ms. Olga, Ukraine
can you write me on address
<olzon@rambler.ru>
I've just taken the plunge and bought 2 of the NX400 modules offered by class-d
http://www.classd.ltd.uk/product.php?productid=16270&cat=257&page=1
£48 each, ouch!
I also ordered a nice big toroidal 800VA 55V-55V from Farnell and a couple of 33,000 uF 63V capacitors: Should be a good Power Supply combination, although I'll need to look for some good Rectifiers.
I've built my own amp before - 15 years ago using the Maplin 150W Mosfet kit! Powered by a 35V-35V toroidal and it's showing it's age now; I reckon there are dry joints everywhere especially as I smoke 20 a day! (Still souns awesome though!)
Star earthing, premium components, my new beast will cost in excess of £500 to build, I'll keep you updated!
Here's my last project:
Can't wait to get my teeth into the latest project 🙂
http://www.classd.ltd.uk/product.php?productid=16270&cat=257&page=1
£48 each, ouch!
I also ordered a nice big toroidal 800VA 55V-55V from Farnell and a couple of 33,000 uF 63V capacitors: Should be a good Power Supply combination, although I'll need to look for some good Rectifiers.
I've built my own amp before - 15 years ago using the Maplin 150W Mosfet kit! Powered by a 35V-35V toroidal and it's showing it's age now; I reckon there are dry joints everywhere especially as I smoke 20 a day! (Still souns awesome though!)
Star earthing, premium components, my new beast will cost in excess of £500 to build, I'll keep you updated!
Here's my last project:
Can't wait to get my teeth into the latest project 🙂
Not expensive at all I reckon for a 400W mono - £48/per channel!
Do let us know how these sound when you get them rigged up!
Do let us know how these sound when you get them rigged up!
In the end I got a few stereo amp modules from these guys:
http://connexelectronic.com/
the TA3020, DA-1 and a TA2022
The prices are very good and the build quality is excellent. Also, these are Class D 😉
I'm still building the power supplies and chassis. Will do reviews on my website when they are finished.
col.
http://connexelectronic.com/
the TA3020, DA-1 and a TA2022
The prices are very good and the build quality is excellent. Also, these are Class D 😉
I'm still building the power supplies and chassis. Will do reviews on my website when they are finished.
col.
I haven't had any communication from Class-D design despite cancelling my order a few days ago via email. The money is gone from my Paypal account, and has not been refunded yet.
If you're reading this, Class-D design, would you be so kind as to PM me with the current situation? Many thanks, Richard.
If you're reading this, Class-D design, would you be so kind as to PM me with the current situation? Many thanks, Richard.
Still no Communication 🙁 I've sent emails to:
louise@class-d.com
sales@class-d.com
as well as, initially, their web contact form on the day of Purchase (5th February) to cancel
So beware if you are thinking about buying anything from class-d.com because it looks like I have lost £96 (Oh, I recieved a couple of badly soldered amp modules a couple of days ago, see below)
High Resolution Image:
http://www.data-designs.net/gfx/amp_modules_high.jpg
What should I do? Start a Paypal Claim?
louise@class-d.com
sales@class-d.com
as well as, initially, their web contact form on the day of Purchase (5th February) to cancel
So beware if you are thinking about buying anything from class-d.com because it looks like I have lost £96 (Oh, I recieved a couple of badly soldered amp modules a couple of days ago, see below)
High Resolution Image:
http://www.data-designs.net/gfx/amp_modules_high.jpg
What should I do? Start a Paypal Claim?
- Status
- Not open for further replies.