Good evening
I‘m inclined to go with a ladder type attenuator, but fray off by the steep price tag...
On the other hand there‘s those relay solutions, where the resistor network is On a pcb, connected to a switch, or glasshouse‘s passive pre...
not being electronics-savvy, I ask myself and the community if it wasn’t possible to build the ladder on a breadboard/pcb and wire it up to the switch (24 steps), thus saving on the switch‘s price tag as well as its size? (2 Decks instead of 4...)
Quite possible that I didn’t get the principle, I’m beginner)
Thoughts?
David
I‘m inclined to go with a ladder type attenuator, but fray off by the steep price tag...
On the other hand there‘s those relay solutions, where the resistor network is On a pcb, connected to a switch, or glasshouse‘s passive pre...
not being electronics-savvy, I ask myself and the community if it wasn’t possible to build the ladder on a breadboard/pcb and wire it up to the switch (24 steps), thus saving on the switch‘s price tag as well as its size? (2 Decks instead of 4...)
Quite possible that I didn’t get the principle, I’m beginner)
Thoughts?
David