I though I would chime back in here because my KSA150 is back with the Australian Distributer for repair (Somthing wrong with the auto bias curcuit) I was told even though they are the Australian distributer for Krell. They have no schematics of any of their amps as Krell refuse to give them out.
I think the repair guy needs a medal once it's fixed but seriously what can I expect to get back? I have heard other horror stories of Krell repairs but if no one but Krell have the schematics, then it's at least $1000 bucks to send it to the U.S. to get fixed.
fingers crossed.
I think the repair guy needs a medal once it's fixed but seriously what can I expect to get back? I have heard other horror stories of Krell repairs but if no one but Krell have the schematics, then it's at least $1000 bucks to send it to the U.S. to get fixed.
fingers crossed.
Krell stuff's not service friendly
http://www.diyaudio.com/forums/solid-state/68317-krell-ksa-250-schematics-3.html#post2969748
http://www.diyaudio.com/forums/solid-state/68317-krell-ksa-250-schematics-3.html#post2969748
HI
I am looking for schematics of the slow start board for a KSA 250 first generation (vertical binding posts on the rear panel) or pictures in order to check the value of the components. Thank you in advance
I am looking for schematics of the slow start board for a KSA 250 first generation (vertical binding posts on the rear panel) or pictures in order to check the value of the components. Thank you in advance
- Status
- Not open for further replies.