Can't host the schematic here, so this isn't going to work-
I just picked up a set of model 24 KLH speakers and am reworking them using the original drivers, inductor and replacing caps. Schematic 1 is how mine is wired. Schematic 2 is the second generation of the 24's that I am planning on implementing. Botton line I am trying to figure out the value of the inductor in Schematic 1.
I have, using an online calculator, figured the cutoff frequency of the first diagram- The tweeter fc is 9.xxx kHz. (seems off to me) Feel free to check my math on that.
Question- So what would be the low pass cut off frequency likely be?- it has that single inductor. I have looked high and low for a value for the inductor; never found it. I was planning to use the old inductors, but I have no way if they are the same in both versions.
Thanks for any insight or answers...
I just picked up a set of model 24 KLH speakers and am reworking them using the original drivers, inductor and replacing caps. Schematic 1 is how mine is wired. Schematic 2 is the second generation of the 24's that I am planning on implementing. Botton line I am trying to figure out the value of the inductor in Schematic 1.
I have, using an online calculator, figured the cutoff frequency of the first diagram- The tweeter fc is 9.xxx kHz. (seems off to me) Feel free to check my math on that.
Question- So what would be the low pass cut off frequency likely be?- it has that single inductor. I have looked high and low for a value for the inductor; never found it. I was planning to use the old inductors, but I have no way if they are the same in both versions.
Thanks for any insight or answers...
Last edited: