It doesn’t play as expected with the Q232 out, same protection triggered at minimal gain adjustment. That specific transistor you requested removed a couple post back you said it’s a part of the protection circuit.
Reinstall that transistor (if you removed it).
Remove R245. Does that allow the amp to play?
If so, reinstall it and lift Q94 and Q95 one at a time to see if either out of the circuit allows the amp to play.
Remove R245. Does that allow the amp to play?
If so, reinstall it and lift Q94 and Q95 one at a time to see if either out of the circuit allows the amp to play.
Last edited:
The amp is the same problem with the resistor removed and both transistors removed alternately has the same effect triggered protection.
Posting about the two amp is just in the essence of time it would take to get a feedback on here about the problems so I just do that to keep busy. But if it’s rather confusing I’ll let this one finished first then. Thanks for the understanding.
Posting about the two amp is just in the essence of time it would take to get a feedback on here about the problems so I just do that to keep busy. But if it’s rather confusing I’ll let this one finished first then. Thanks for the understanding.
- Status
- Not open for further replies.