Place the board in the panel and mark the sensitivity pot. That's VR1. The rest of the pots (VR2-VR4) are different than VR1 but the same as each other. If you need the gain/sensitivity pot, order the part number for VR1. If you need any of the other pots in that group, order the other part number.
thanks lots perry
i ordered one of each so i ordered a total of 2 one for the input sensitivity and one for the b.m.s freq
ya perry i dont think i would of gotten the right parts with out you bro thanks lots n lots i sure hope itll be an easy fix and if so itll rock
i seen a new one on ebay for like 100.00+
thanks
Somedude
i ordered one of each so i ordered a total of 2 one for the input sensitivity and one for the b.m.s freq
ya perry i dont think i would of gotten the right parts with out you bro thanks lots n lots i sure hope itll be an easy fix and if so itll rock
i seen a new one on ebay for like 100.00+
thanks
Somedude
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- General Interest
- Car Audio
- Kenwood kac-x201 (part numbers)