Hi Guys, I ave looked through the various threads, and not found an answer yet...
I have repaired the above-mentioned amp, but for one component.
The zener diode D5, right in the middle of the board, between the amplifier channels.
It has only "C10" marked on it.
I have temporarily fitted a 10v zener in here, but would just like confirmation of the correct component voltage, etc.
The faults with the amp were this zener, and a broken SMT resistor adjacent to one of the output devices.
Thanks in advance.
Simon
I have repaired the above-mentioned amp, but for one component.
The zener diode D5, right in the middle of the board, between the amplifier channels.
It has only "C10" marked on it.
I have temporarily fitted a 10v zener in here, but would just like confirmation of the correct component voltage, etc.
The faults with the amp were this zener, and a broken SMT resistor adjacent to one of the output devices.
Thanks in advance.
Simon
- Status
- Not open for further replies.