Is the ground for the signal generator connected to the power supply ground?
I've been meaning to make a ground connection for this signal generator. It does not appear to have one readily attachable.
Maybe I shoult try my iPod, but I'm affraid I might burn it out.
OK this amp is fixed. I guess I need to make a grounding point for my frequency generator, because my iPod is working just fine.
The fix for this amp was 3 caps near the outputs and 1 5w5ohm resistor. Plus a lot of cleaning supplies.
Also this amp has a load of dirty switches for which Ive found some contact cleaner and WD40 works very well to fix.
The fix for this amp was 3 caps near the outputs and 1 5w5ohm resistor. Plus a lot of cleaning supplies.
Also this amp has a load of dirty switches for which Ive found some contact cleaner and WD40 works very well to fix.
Last edited:
Im in the same boat this guy was, i have the exact same blown parts.
Mouser wont have DME2W6P8K-F Cornell Dubilier Polyester Film Capacitors
in stock until the end of may.
Is this a suitable replacement? or is the temp rating to low.
http://www.mouser.com/ProductDetail...=sGAEpiMZZMvOcEq4GH1AAnaCoOhkJpOzBTqjT6QlI3M=
Mouser wont have DME2W6P8K-F Cornell Dubilier Polyester Film Capacitors
in stock until the end of may.
Is this a suitable replacement? or is the temp rating to low.
http://www.mouser.com/ProductDetail...=sGAEpiMZZMvOcEq4GH1AAnaCoOhkJpOzBTqjT6QlI3M=
would a 5ohm 10 watt wirewound resistor be usable?
I Cannot find a 5ohm 5 watt in the right package type.
this is the only thing i can find at digi, but i think i will have space issues.
http://search.digikey.com/scripts/DkSearch/dksus.dll?Detail&name=CB5JB5R00-ND
I Cannot find a 5ohm 5 watt in the right package type.
this is the only thing i can find at digi, but i think i will have space issues.
http://search.digikey.com/scripts/DkSearch/dksus.dll?Detail&name=CB5JB5R00-ND
Last edited:
I don't think that I've ever seen one of these amps with this problem so I wouldn't expect it to be a common problem.
A 10w resistor would work if you could find one to fit. The one you listed may work if the leads could be bent to fit the board spacing.
I'd think that it would be very difficult to burn both resistors open since they're in series. It's probably not very common.
A 10w resistor would work if you could find one to fit. The one you listed may work if the leads could be bent to fit the board spacing.
I'd think that it would be very difficult to burn both resistors open since they're in series. It's probably not very common.
My 1000/ has no output. While taking it apart c515 came out. It looks like someone repaired this and r536 (diagonal of c515) 493-3526ND will work for c515? Which 5w5ohm did you go with? I just picked up a scope,ddm, and soldering station. Should i post a new thread when I'm ready?
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- General Interest
- Car Audio
- JL Audio 1000/1