Hi everyone
Have bought the Jab3 with DSP and 2x50 w.
Hooked it up today to test it, with my drivers and for some reason i only got the slightest of sound from the woofer and tweeter. Almost just a whisper.
Hope you can see my attached images.
I'm clearly doing something wrong!
Used line in and hooked up my iPhone on spotify.
For the woofer i used 1 and 2 ( 4 pin with 4 wires called 1,2,3,4) and for the weeter 3 and 4.
Did not however think it would matter if wire 1 went to a specific input on the speaker ? I am a noob 🙂
In the DSP i made a simple crosser over - so not really anything I have made wrong there .. yet.
I just don't understand why it would play at a whisper and not just as a speaker would normally. Does anyone have ANY hint for me ?
Have bought the Jab3 with DSP and 2x50 w.
Hooked it up today to test it, with my drivers and for some reason i only got the slightest of sound from the woofer and tweeter. Almost just a whisper.
Hope you can see my attached images.
I'm clearly doing something wrong!
Used line in and hooked up my iPhone on spotify.
For the woofer i used 1 and 2 ( 4 pin with 4 wires called 1,2,3,4) and for the weeter 3 and 4.
Did not however think it would matter if wire 1 went to a specific input on the speaker ? I am a noob 🙂
In the DSP i made a simple crosser over - so not really anything I have made wrong there .. yet.
I just don't understand why it would play at a whisper and not just as a speaker would normally. Does anyone have ANY hint for me ?
Attachments
Are you sure you have oploaded the program correctly?
Try turning on the dials, there's 4 of them. One of them controls the volume, so it could be that it is dialed all the way down.
Try turning on the dials, there's 4 of them. One of them controls the volume, so it could be that it is dialed all the way down.