Introduction

[Gautam Rajput]

Hi everyone i am an avid music lover, i listen to trance techno and punjabi bhangra. i am keen to design a low power amplifier of about 50 w rms.

I would really appreciate some advice on hoe to begin designing as i am currently doing by B.E. in electronics ( S.E.).

Any suggestion or advice is most welcome.

 

[Netlist]

Hi Gautam
Trance and techno are somehow the trademark of Belgium but I haven't the faintest idea what punjabi bhangra is. Care to provide a link with a sample song?
As for your amplifier, a lot depends on what you want to build. Tube, solid state...perhaps class A?

Anyway, welcome to the forum.

/Hugo 🙂

 

[Cal Weldon]

Welcome to the forums Gautam.

 

[Gautam Rajput]

Hi Gautam
Trance and techno are somehow the trademark of Belgium but I haven't the faintest idea what punjabi bhangra is. Care to provide a link with a sample song?
As for your amplifier, a lot depends on what you want to build. Tube, solid state...perhaps class A?

Anyway, welcome to the forum.

/Hugo 🙂

Hi Hugo,

Thanks for replying,

About Punjabi Bhangra, Its North Indian music very famous in India, unfortunately not available on net.

About Amplifier, I was thinking about class ab, but ifyou have any other ideas, you are most welcome to post.

Any ways my email is gautamrajput2603@yahoo.com if you wish to email something important.

 

[Sundance]

Hi Gautam,

easy and simple stock Hypex moduls, free bass no distorsion lot of power🙄

sundance

 

[pinkmouse]

About Amplifier, I was thinking about class ab, but ifyou have any other ideas, you are most welcome to post.

Searching here on some of these will give you lots of ideas:
AKSA
P3A
SKA
KrellClone
Leach

And there's a whole forum full of chip amps that are quite fun as well. 🙂